This coupler (rag joint) is required to connect the steering column to the steering box.
Coupler Specs:
Shaft Size: 3/4" coarse spline with flat at bolt head side
Spline Count: 25
Total OD: 3-1/4"
Bolt Size: 5/16"
Bolt…
This is the ball stud in the end of the power valve. Usually needed when rebuilding your power steering system. Reduces steering wheel play. Includes seal and clamp. Fits 62/64 Galaxies and all Other models with power ram style steering…
This is the stud and bolt kit for Saginaw power steering pumps. Includes (2) studs (3/8"-16 thread), (1) bolt 3/8"-16 thread). Fits most Saginaw pumps through 1977 including Saginaw P series. This set is unplated for use with painted…
This Boot kit is brand new reproduction with correct design, made of the best materials. This set contains bushings, washers, spacer, lock nut and cotter pin.1 Year Manufacturer WarrantyReproduction Power Steering Boot KitPairs With PS1010…
Repair torn and worn-out boots of suspension tie rod ends - without having to buy the entire and expensive tie rod. Adds durability surpassing most OEM rubber boots. Exclusive 5-point sealing action. Choose from four sizes and round or…
New Rag Joint steering couplers are carefully engineered to OE specifications. All units are complete with lower casting, rubber disk and mounting bolts already assembled for easy, trouble free installation. All units are carefully…
New Rag Joint steering couplers are carefully engineered to OE specifications. All units are complete with lower casting, rubber disk and mounting bolts already assembled for easy, trouble free installation. All units are carefully…
These fasteners are factory correct down to the finish and the markings. A must have for the concours restoration or just those that want peace of mind of having factory correct hardware on their ride, instead of the garden variety…
Inner tie rod for V8 engines. For power steering fits right side only. For manual steering fits right or left side. Designed and built to meet OEM specifications.
…
New Rag Joint steering couplers are carefully engineered to OE specifications. All units are complete with lower casting, rubber disk and mounting bolts already assembled for easy, trouble free installation. All units are carefully…
Quality replacement hoses. Aftermarket type hoses without original Ford markings in most cases. Made in the usa.1967 through 1968 Fairlane and Mustang 289/302 and six cylinder engines. 1967 through 1970 Falcon six cylinder only.
…
Factory-correct reproduction of the pitman arm that connects steering gear sector shaft to center link
Direct fit replacement requires no additional modification; Sized for 1 1/8" sector shaft
OE-spec dimensions and angles retain…
Direct-fit replacement secures power steering hoses within isolator bracket located under the driver side lower control arm
Properly routes hoses away from exhaust header while maintaining required slack at control valve…
Reproduction Of Original Correct replacement outer tie rod ends are available for most models of Galaxie. Only Fits Manual Steering cars 60/ 62 - Does Not Fit 427 Equipped Cars From 63/ 64.
…
New for 2007 is a reproduction power steering control valve end cap. Now you can do a more complete rebuild of your power steering control valve. Made in the u.S.A.
…
New return lines for your power steering system. Replace these along with the pressure line (ppl series) and help eliminate those annoying drips from your ride. This is a plain section of power steering return hose without fittings Power…
New return lines for your power steering system. Replace these along with the pressure line (ppl series) and help eliminate those annoying drips from your ride. Power steering return line for the 1963-1964 Galaxie with the fe 352/390 v-8…
Direct-fit replacement installs on the power steering pump as part of the engine's accesory drive
Factory-correct reproduction restores original appearance and functionality, or adds it if converting from manual steering
…